bjuice

here are my et's so far....

67 camaro PRO-STREET 3,000 LBS
1.39 60 FT
6.07 ET 1/8 MILE
MPH 115
500 gear
180 straight cut glide
this was on the foot brake and hard 14x32's (102 roll out) on 14 inch wheel. i now have 15 inch wheels and 17x33's (101 roll out) stiff side wall..i have a 2 step in place for tranbrake....so i hope to go in some low 90's or high 80's
-------------------------------------------------------------------------------------

63 Corvette chrome moly chassis,sheet metal fabbed rear end
weighs 2100 lbs without driver
632 aluminum donovan block, EPD sheet metal intake pair of chuck nugtteyn dominaters,ponitac 14 degree big chief heads. 1200 hp @7600 and 980 ft lbs of tq
430 pro-gear with 15 inch wheels and 16.5x33's (104) roll out soft side wall.
180 straight cut glide.

i have never run the car..i hope to have out in mid June....

i will give a hint on what it ran with a 598 iron block..200/300 hp less than what i have now and 150 lbs Heavier..
5.0's and teens with a 1.12-1.14 60 ft on good track....


i WOULD LIKE SOME OPINIONS ON WHAT YOU THINK THE VETTE WILL RUN......


opps sorry i weigh in bertween 215lbs and 220lbs

Thanks- Brian