Originally Posted by fla1976
The dowels are press fit. You can tap them out. It sounds like they are just in too deep. Your mid plate is normally only about an eighth inch thick.
Once again...thanks. It turns out the stock ones are 1"
the ones I bought are 1 5/8". The midplate is 1/4" and that was part of the problem. The 1 5/8" now stick out 1/2" past my midplate. perfect. I was affraid that if I used the 2" or even 2 1/2" that I saw in Jegs/summit that it could be a problem sliding my trans back in order to remove when needed. Its a tight area right there in this tube chassis.
Thanks for the help guys!!
