(This is a tuff decision and an expensive one I dont want to get this wrong.)
I hear that,
You can probably install the cam at 108* and cover a little bit of the bottom end torque. Other thing is, even though we have a 5500 stall converter, we're leaving on a 3800 chip, so we're smacking the converter pretty hard.
This is all marginal, it could be a GO or it could be a BUST and i wouldn't want to be the one to make that decision. One thing is if it does not work, they will usually regrind to a different spec. for a $100.00.
Zip.